Ali ATA/Serial ATA RAID Driver
I have been dowloading kext after kext of different possible ata 10b ALi Corporation ALi M Serial ATA / RAID Host Controller. Type: Add On Cards,PCI To USB Card,PCI To Card,PCI-E To USB Card,PCI-E 4X To 16X Card. "Bought a Plextor PXSA which is "Serial ATA" by mistake. To get it working need to buy a controller card. Bought a ALI M SATA but there driver CD.
|Supported systems:||ALL Windows 32x/64x|
|Price:||Free* [*Free Registration Required]|
Ali ATA/Serial ATA RAID Driver
- PCI\VEN_10B9&DEV_ - ALi M Serial ATA / RAID Host Device Hunt
- Got Everything working except my ALi Sata/ATA card - SATA/IDE Controllers - InsanelyMac Forum
- PCI to 4 Ports SATA CONTROLLER RAID CARD 4 SATA SERIAL ATA PCI CONTROLLER RAID CARD
- M5281/M5283. Serial ATA and Parallel ATA Host Controller. RAID BIOS/Driver/Utility Manual
- 2 posts in this topic
All rights reserved. No part of this document may be reproduced or transmitted in any form or by any means without the written permission of ULi Electronics Inc.
Serial ATA controller - ALi BIOS Tom's Hardware Forum
The information in this document is subject to change, as ULi Electronics Inc. ULi Electronics Inc. Contact ULi Electronics Inc. Pentium is a trademark of Intel Corporation. Windows is a Ali ATA/Serial ATA RAID of Microsoft Corp. All other product names or trademarks are the property of their respective owners.
Added Reference Messages chapter. Modified BIOS menu. Added hot plug support in sections 1.
M/M Serial ATA and Parallel ATA Host Controller. RAID BIOS/Driver/Utility Manual - PDF
Modified Troubleshooting Item 7. Revision 0. Introduction 1. The following is the comparison table between M and M Page 6 Document Number: Identifying IDE drive.
Maxtor 4AJ0 Channel 0 Slave: Maxtor 6LJ2 Channel 1 Master: None Channel 1 Slave: None Channel Ali ATA/Serial ATA RAID Master: Select Stripe Size 64K: The following uses M setup screen for illustration: None B Channel 2 Master: Press Enter key to activate this item. Press Y, and then some necessary information will be written to the drives, which will destroy the original data in the drives.
Serial ATA controller - ALi BIOS
Ali ATA/Serial ATA RAID sure the data in drives is no longer in use before creating RAID Next, the Array Name input line appears for the user to key in a name for the newly created array. The effective characters for an array name isA - Z, a - z, space and underscore. It is recommended to use new drives to create RAID 1.
If existing drive is to be used, backup all necessary data before creating RAID Press Y, and then some necessary information will be written to drives, which may destroy the original data in the drives. Next, the Array Name input line appears for the user to key in a name for the newly created array.
The source and target drives are Ali ATA/Serial ATA RAID by M and m in Drive Select Menu respectively. Pressing Y will duplicate the data in source drive to the target drive. Make sure the source drive is the correct one.
If you press N, then the data is inconsistent in two drives. The process status bar shows up during the duplication process. Four Parallel ATA drives are automatically selected.
Press Y, and then some necessary information will be written to drives, which may destroy the original data in the drives. The maximum number of drives for JBOD array is four and the minimum is Ali ATA/Serial ATA RAID. Press Y key and then some necessary information will be written to drives, which may destroy the original data in the drives.